Hi everyone, I have the Digirig connected to the a Yaesu FTM-300DR using the 10 pin mini Din connector connected to the audio port of the Digirig. This is all connected to a Microsoft Surface Go 3 via usb c. Things were working great for 24 hours, until there weren’t. I fired the system up today…

Richard, If cable proves to be faulty, I can handle the exchange for you. Now, using the continuity tester please check if the lines are all connected. Note that the drawing is for the solder side. The pinout is mirrored when looking from the outside. Use wider gap between pins 8 and 9 as the clue…

This was very helpful. Thanks. I did the quick test of shorting the sleeve with the closest ring (R2). No PTT. I then checked continuity of all pins. R2 to pin 3 of the mini DIN 10 connector does not have continuity. The other 3 checked out fine. I’m surprised that I’m not hearing audio since…

Please DM me the order information and I’ll send you the replacement cable.

Thanks for the prompt replacement Denis. Received the cable yesterday and everything is working great! Richard

I’m actually having the same issue. No PTT. (I think) New to digital. So I don’t have a lot of background here. But here is my setup: Windows 10 laptop FLDIGI V4.x.x.x (the latest) Digirig 1.9 (brand new) Yaesu MiniDin10 9600-baud Data and CAT Cable for Digirig Mobile (Brand new) FTM-6000…

Here’s the video I posted for another operator showing the WSJT-X and FlDigi settings for non-CAT capable radios: [PTT by RTS test in WSJT-X and FlDigi]

Digirig Forum

Need help troubleshooting no PTT

Uncategorized

troubleshoot-ptt

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled