I had recently posted about using my Mackie prov3 to control my TM-V71A which initially seemed straight forward but the deeper I dig the more difficult it becomes. This was the main reason I went with the digirig otherwise I could have status quo. Next thought was to use the mixer built in USB port but that presents two problems, programing digirig software and the mixer’s port has no power which the digirig needs. I might be able to get around that issue with a small, powered hub, but that leaves the programming issue. Appreciate any input and discussion. Otherwise, I’ll be back to status quo and a digirig I don’t need. I really enjoy this site, very helpful. Bob 73
Thanks for explaining your process.
73 Constrainted