Kenwood TS-830s

[K0TX]

At this time there is no pre-made cable for TS-830S. Please check out this post for the information on a homebrew build:

Cable for 4-pin Kenwood mic connector

Here’s the pinout for 4 pin mic connector on older Kenwood transceivers: [image] [image] Based on that the Digirig audio cable will look like this: pin 1 MIC → 3.5mm TRRS ring 1 (RIG_AFIN) pin 2 PTT → 3.5mm TRRS ring 2 (RIG_PTT) pin 3 GND → 3.5mm TRRS sleeve (GND) pin 4 MIC GND → 3.5mm TRRS sleeve (GND) 6.35mm TRS tip (PHONES) → 3.5mm TRRS tip (RIG_AFOUT) Please report the results of your build.