Yaesu FTM-6000 CAT config

[K0TX]

I don’t own this transceiver so the information comes from other operators.
In the below thread the poster ultimately reported the Yaesu FTM-6000 based setup working with RS-232 configuration:

Readout of FTM-6000 with YAESU miniDin10 &CAT cable gives 'Format error'

Connected green plug of YAESU DATA&CAT cable to serial socket of digirig. Started ADMS-13 SW and tried to readout FTM-6000. TRX goes into mode ‘CLN Tx’ as described. When RX is started in ADMS-13 and then the DIAL button on the TRX is pressed, ADMS-13 immediately says ‘Format Error’. On the TRX, the message ‘SND.ERR’ appears. The COM port on the PC is recognized properly and it is correctly set in ADMS-13. Tried several baud rates and with/without HW-handshake. No luck. Has anybody been success…